15
Additional functions
<Auto return system>
The watch automatically returns to the Time Mode if the function hand remains at 0 meter(0ft) for longer
than 30 minutes in the Diving Mode.
<Abnormal activation prevention function >
If the depth meter is functioning abnormally for some reason, the function hand will point to the Over Zone
Mark when the watch is switched to the Diving Mode, and depth measurement will not be possible. In such a
case, switch back to the Time Mode.
Diving Mode
14
0m
3
6
9
12
15
30
20
40
50
EXIT
2
4
4
8
12
16
20
.0
.2
.4
.6
.8
DV
10
20
30
40
5
0
DV
A
B
C
E
G
F
1
Display in the Diving Mode
Please refer to the fold-out watch diagram
located on the opening page of this manual.
A - Depth indicator hand (function hand)
B - Points to DV
C - Minute hand
E - Hour hand
G - 24-hour time hand
F - Second hand
* If the hands A, B do not point to the correct position,
please readjust them according to the "ALL RESET" instruc-
tions on page
23.
Reading the Depth
While diving, the number indicated by the
depth indicator hand A (the function hand) is
the present diving depth. The depth indicator
hand begins to function at a depth of 1 meter
(5ft). It registers depths less than 1 meter (5ft)
as 0. At depths over 50 meters (125ft), the
hand stops on the Over Zone Mark (53 min-
utes) and remains there until returning to
depths less than 50 meters(125ft).
Measurements and Range
Display range: 0 m(0ft) to 50 m(125ft)
Display increment: 1 meter(2.5ft)
Measurement interval: Once/second
About depth readings
1.After switching to the Diving Mode, depth read-
ings will commence automatically when diving
begins.
2.The depth will be measured and displayed in 1 meter
(2.5ft) increments up to 50 meters(125ft).
NOTE: 1.A depth less than 1 meter(5ft) is not recorded.
2.The data in the maximum depth memo will be cleared when the battery reaches the end of its life. Be
sure to record necessary memo information in a log book.
3.The first time this function is used, it may display data that was used in product testing.
4. Depths over 50 meters(125ft) will be recorded as the Over Zone Mark.
Calling the maximum depth memo
1.While in the Time Mode or Diving Mode (a depth of 0 is displayed)
press button 2. The function hand A will display the maximum depth.
2.
Pressing button 2 a second time or leaving the memo displayed contin-
uously for 30 seconds will release the maximum depth memo display.
This watch automatically records the maximum depth reached during a dive (in 1 meter(2.5ft) increments). This
memo is retained until the watch is set to the Diving Mode again and a depth of 1 meter(5ft) or more is reached.
[ Maximum depth memo function ]
: From the Time Mode, or the Chronograph Mode, switch to the Diving Mode by pressing but-
ton1 continuously for 2 seconds.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales