Citizen CBM-910 Type II Especificaciones descargar pdf (Pagina 18)

Etigam BRIGHT-CHEQ Biological Indicator Monitoring System

BRIGHT-CHEQ Incubator Operation Manual

CONFIGURING INDIVIDUAL CELLS

Each incubation cell can be independently congured by touching its corresponding key on

the MainMenu. There are ten incubation cells numbered 1 through 10, and one positive

control incubation cell marked by the letter C.

To bring up the Cell Menu for

any incubation cell, touch the

corresponding key on the Main

Menu.

Cell Menu

Each incubation cell should be properly congured prior to use, and as needed over time.

The following parameters can be congured for each individual incubation cell:

• Etigam BRIGHT-CHEQ BI Lot Number - the lot number of the BRIGHT-CHEQ BI being

tested.

• SterilizationCycleNumber - the identication number of the cycle in which the BRIGHT-

CHEQ BI was exposed.

• OperatorInitials - the initials/identication number of the operator responsible for the

test in the selected cell.

• SterilizationCycleType - the type of cycle to which the BRIGHT-CHEQ BI was exposed.

• SterilizationTemperature- the temperature of the cycle to which the BRIGHT-CHEQ BI

was exposed.

• SterilizationExposureTime - the exposure time of the cycle to which the BRIGHT-CHEQ

BI was exposed.

The conguration values entered for each incubation cell

appear on test report printouts only, and have no aect on

the operation of the incubator.

As a user convenience, individual cell congurations do not

reset upon test completion. The settings entered for each cell

will remain active until they are changed by the operator.

CONFIGURATION - CELL SETTINGS



1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Sin comentarios

Citizen CBM-910 Type II Especificaciones Pagina 18